VSync 924 Especificaciones descargar pdf (Pagina 123)

Connectors on Matrox Solios eCL/XCL dual-Base/single-Medium and eCL/XCL-F boards 123

When the board is configured in single-Medium or single-Full mode, the first

connector has the pinout described above, while the second connector has the

following pinout.

To interface with the above connectors, use a standard Camera Link cable. You

can purchase such a cable from your video source manufacturer, 3M Interconnect

Solutions for Factory Automation, Intercon 1, or other third parties. Note that

this cable is not available from Matrox.

❖ If using both Camera Link connectors to connect to the same video source

(single-Medium mode or single-Full mode), the cables you choose must be of the

same type and length. Otherwise, the cables can have different propagation delays.

Pin Hardware signal name Description

1 Inner shield Ground (inner shield), or +12V to camera in PoCL mode.

2+,15- Z3

Video input data Z3.

*. When the board is configured in single-Medium mode, these pins are reserved.

3+,16- Zclk+

Clock input Z.

4+,17- Z2

Video input data Z2.

5+,18- Z1

Video input data Z1.

6+,19- Z0

Video input data Z0.

7terminated

Unused.

8+,21- Y3 Video input data Y3.

9+,22- Yclk Clock input Y.

10+,23- Y2 Video input data Y2.

11+,24- Y1 Video input data Y1.

12+,25- Y0 Video input data Y0.

13 Inner shield Ground.

14 Inner shield Ground.

20 100 Ω

Unused.

26 Inner shield Ground (inner shield), or +12V to camera in PoCL mode.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 159 160

Sin comentarios

VSync 924 Especificaciones Pagina 123